Metal, Cement Fibre, Plastic Rooves Standards

These are the Metal, cement fibre, plastic rooves Standards

The Metal, Cement Fibre, Plastic Rooves set provides guidance to roofers.

Guidance also includes damp-proofing and flashings, and glass in buildings, especially for skylights.

Project managers, builders, carpenters, engineers and technicians will also find the guidance invaluable.

Available in the Metal, cement fibre, plastic rooves set.

Name	Publisher
AS 1562.1:2018 Design and installation of metal roof and wall cladding, Part 1: Metal	Current Standards Australia	This Standard sets out requirements for the design and installation of self-supporting metal roof and wall cladding, subjected to out-of-plane external actions and in-plane thermally induced actions, permanent actions on walls and steep roofs and frictional drag of wind and snow actions.
SA HB 39:2015 Installation code for metal roof and wall cladding	Current Standards Australia	Provides information and guidelines on the selection, performance and installation of metal roofing and wall cladding.
AS 4440-2004 Installation of nailplated timber roof trusses	Current Standards Australia	Specifies basic requirements for the bracing, connection and installation of nailplated timber roof trusses. Requirements are given for supporting structures, roof truss installation, roof bracing, truss connection and overhangs.
AS/NZS 2904:1995 Damp-proof courses and flashings	Current Standards Australia/Standards New Zealand	Specifies the requirements for damp-proof course and flashing materials of the sheet membrane, strip and collar type for use in building construction.
AS/NZS 1562.2:1999 Design and installation of sheet roof and wall cladding, Part 2: Corrugated fibre-reinforced cement	Current Standards Australia/Standards New Zealand	Sets out requirements for the materials, design and installation of corrugated fibre-reinforced cement roof and wall cladding; provides test procedures for the determination of resistance to wind force; appendix gives advice on the provision of roof ventilation.
AS 1562.3-2006 Design and installation of sheet roof and wall cladding, Part 3: Plastic	Current Standards Australia	Specifies procedures for the design and installation of plastic roof and wall cladding materials for walls and roofs.
AS 1288-2006 Glass in buildings - Selection and installation	Available Superseded Standards Australia	Specifies procedures for the design, selection and installation of glass in buildings; includes guidance for installation practice, based on proven techniques.
AS 3999:2015 Bulk thermal insulation - Installation	Current Standards Australia	Sets out requirements on installing insulation in both new dwellings during construction and the retrofitting of insulation in existing buildings.
AS 4654.2-2012 Waterproofing membranes for external above-ground use, Part 2: Design and installation	Pending Revision Standards Australia	Sets out a consistent and reliable approach to the design and installation of external waterproofing membrane systems.
SA HB 39:2015 Amd 1:2021 Installation code for metal roof and wall cladding	Current Standards Australia	SA HB 39:2015 is amended as follows.
AS 1288:2021 Glass in buildings - Selection and installation	Current Standards Australia	Sets out procedures for the selection and installation of glass in buildings, subject to wind loading, human impact, and special applications. Glass strength is specified, based on the tensile stresses on the surface of the glass.