Search all content

1 - 10 of 24 results
AS 5637.1:2015 Determination of fire hazard properties, Part 1: Wall and ceiling linings 2015 cover

Standards Australia

Version:  First Edition 2015.  (Current)
Sets out procedures for the assessment of internal wall and ceiling linings according to their tendency to ignite; their tendency to release heat once ignition has occurred; their tendency to cause flashover; their tendency to release smoke; and their contribution to fire growth.
AS 1735.11-1986 SAA Lift Code, Part 11: Fire-rated landing doors 1986 cover

Standards Australia

Version:  Third Edition 1986.  (Current)
Sets out requirements for fire-rated landing doors for retarding the passage of fire through openings in fire-rated liftwells; it applies where doors are required to have a fire-rating certificate.
AS 1530.1-1994 Methods for fire tests on building materials, components and structures, Part 1: Combustibility test for materials 1994 cover

Standards Australia

Version:  Third Edition 1994.  (Current)
Sets out a test method for determining the combustibility of building materials and is one of a series of test methods for evaluating the potential fire hazard of building products.
AS 1530.4:2014 Methods for fire tests on building materials, components and structures, Part 4: Fire-resistance tests for elements of construction 2014 cover

Standards Australia

Version:  Sixth Edition 2014.  (Current)
Sets out test procedures and criteria for the determination of fire-resistance of elements of building construction.
AS 2870-2011 Residential slabs and footings 2011 cover

Standards Australia

Version:  Fourth Edition 2011.  (Pending Revision)
Sets out requirements for the classification of a site and the design and construction of a footing system for a single dwelling house, town house or the like which may be detached or separated by a party wall or common wall but not situated vertically above or below another dwelling.
AS/NZS 1530.3:1999 Methods for fire tests on building materials, components and structures, Part 3: Simultaneous determination of ignitability, flame propagation, heat release and smoke release 1999 cover

Standards Australia/Standards New Zealand

Version:  First Edition 1999.  (Current)
Describes a single test method for grading building materials on the basis of ignition tendency, flame spread, heat development and tendency to produce smoke.
AS 3610-1995 Formwork for concrete 1995 cover

Standards Australia

Version:  Second Edition 1995.  (Current)
Specifies requirements for the design, fabrication, erection and stripping of formwork as well as the evaluation and repair of the formed concrete surface; colour evaluation charts are included in an Appendix.
AS 2699.1:2020 Built-in components for masonry construction, Part 1: Wall ties 2020 cover

Standards Australia

Version:  First Edition 2020.  (Current)
This Standard specifies requirements for wall ties for use in tying together the leaves of cavity masonry walls, masonry veneer walls and loadbearing frames, and masonry veneer walls against a strong backing wall.
AS 3700:2018 Masonry Structures 2018 cover

Standards Australia

Version:  Fifth Edition 2018.  (Current)
Specifies minimum requirements for the design and construction of unreinforced, reinforced and prestressed masonry, including built-in components.