Search all content

1 - 10 of 24 results
AS 1562.3-2006 Design and installation of sheet roof and wall cladding, Part 3: Plastic 2006 cover

Standards Australia

Version:  First Edition 2006.  (Current)
Specifies procedures for the design and installation of plastic roof and wall cladding materials for walls and roofs.
AS 2870-2011 Residential slabs and footings 2011 cover

Standards Australia

Version:  Fourth Edition 2011.  (Pending Revision)
Sets out requirements for the classification of a site and the design and construction of a footing system for a single dwelling house, town house or the like which may be detached or separated by a party wall or common wall but not situated vertically above or below another dwelling.
AS 1562.1:2018 Design and installation of metal roof and wall cladding, Part 1: Metal 2018 cover

Standards Australia

Version:  Second Edition 2018.  (Current)
This Standard sets out requirements for the design and installation of self-supporting metal roof and wall cladding, subjected to out-of-plane external actions and in-plane thermally induced actions, permanent actions on walls and steep roofs and frictional drag of wind and snow actions.
AS/NZS 1562.2:1999 Design and installation of sheet roof and wall cladding, Part 2: Corrugated fibre-reinforced cement 1999 cover

Standards Australia/Standards New Zealand

Version:  First Edition 1999.  (Current)
Sets out requirements for the materials, design and installation of corrugated fibre-reinforced cement roof and wall cladding; provides test procedures for the determination of resistance to wind force; appendix gives advice on the provision of roof ventilation.
AS 3610-1995 Formwork for concrete 1995 cover

Standards Australia

Version:  Second Edition 1995.  (Current)
Specifies requirements for the design, fabrication, erection and stripping of formwork as well as the evaluation and repair of the formed concrete surface; colour evaluation charts are included in an Appendix.
AS 3999:2015 Bulk thermal insulation - Installation 2015 cover

Standards Australia

Version:  Second Edition 2015.  (Current)
Sets out requirements on installing insulation in both new dwellings during construction and the retrofitting of insulation in existing buildings.
SA HB 39:2015 Amd 1:2021 Installation code for metal roof and wall cladding 2021 cover

Standards Australia

Version:  First Edition 2021.  (Current)
SA HB 39:2015 is amended as follows.
AS 4654.1-2012 Waterproofing membranes for external above-ground use, Part 1: Materials 2012 cover

Standards Australia

Version:  Second Edition 2012.  (Pending Revision)
Sets out requirements for waterproofing membranes for external above-ground use, installed in accordance with AS 4654.2.
AS 4654.2-2012 Waterproofing membranes for external above-ground use, Part 2: Design and installation 2012 cover

Standards Australia

Version:  Second Edition 2012.  (Pending Revision)
Sets out a consistent and reliable approach to the design and installation of external waterproofing membrane systems.
AS 3740:2021 Waterproofing of domestic wet areas 2021 cover

Standards Australia

Version:  Fifth Edition 2021.  (Current)
Sets out minimum requirements for the materials, design and installation of waterproofing for domestic wet areas in Class 1, Class 2 and Class 4 buildings as defined in the NCC. It also applies to wet areas within Class 3 to 9 buildings as if it were a Class 2 or 4 part of a building.