Sets out requirements on installing insulation in both new dwellings during construction and the retrofitting of insulation in existing buildings.

Sets out requirements for waterproofing membranes for external above-ground use, installed in accordance with AS 4654.2.

Sets out a consistent and reliable approach to the design and installation of external waterproofing membrane systems.

Sets out minimum requirements for the materials, design and installation of waterproofing for domestic wet areas in Class 1, Class 2 and Class 4 buildings as defined in the NCC. It also applies to wet areas within Class 3 to 9 buildings as if it were a Class 2 or 4 part of a building.

Sets out procedures for the selection and installation of glass in buildings, subject to wind loading, human impact, and special applications. Glass strength is specified, based on the tensile stresses on the surface of the glass.

Specifies requirements for the design, installation and commissioning of cold water services from a point of connection to the points of discharge, and for non-drinking water from a point of connection to the points of discharge.

Sets out the requirements for the design, installation and commissioning of heated water services using drinking water or rainwater or a combination thereof; includes aspects of the installation from, and including, the valve(s) on the cold water inlet to any cold water storage tank or water heater and the downstream fixtures and fittings; applies to new installations as well as alterations, additions and repairs to existing installations.

Specifies the procedures for the design and installation of plastic roof and wall cladding materials.

Single-ply, high-polymer, entirely homogeneous synthetic roofing and waterproofing membrane.

From 1 July 2021, Design and Building Practitioners working on class 2 buildings need to register under a new Compliance Declaration Scheme.